WEKO3
アイテム
Experimental of Abrasive Flow Machining on P20 Surface Mold Polishing
http://hdl.handle.net/10458/00010473
http://hdl.handle.net/10458/0001047380355279-5b32-49f4-b8af-b8acd81adda8
| 名前 / ファイル | ライセンス | アクション |
|---|---|---|
本文 (256.9 kB)
|
|
| Item type | 会議発表論文 / Conference Paper(1) | |||||
|---|---|---|---|---|---|---|
| 公開日 | 2023-02-02 | |||||
| タイトル | ||||||
| タイトル | Experimental of Abrasive Flow Machining on P20 Surface Mold Polishing | |||||
| 言語 | en | |||||
| 言語 | ||||||
| 言語 | eng | |||||
| 資源タイプ | ||||||
| 資源タイプ識別子 | http://purl.org/coar/resource_type/c_5794 | |||||
| 資源タイプ | conference paper | |||||
| 著者 |
Maneepen, T.
× Maneepen, T. |
|||||
| 抄録 | ||||||
| 内容記述タイプ | Abstract | |||||
| 内容記述 | The paper presents the effect of the clearanceof specimens and tools for surface roughness (Ra) of P20 mold steel that is related to abrasive flow machining (AFM). This study experimented with flat specimens. AFM experiments are performed to identify the improved surface roughness when applied to the polishing specimens. Specimens were prepared by turned, hardened, and polished with sandpaper from number P40 and measured an original value of Ra compared with the final value of Ra at the end of the process. The process parameters are as follows: an abrasive particle size (Al2O3) of 5.0 μm in water (50 % concentration by weight), the pressure of 7 bar, hardness of specimens 30±2 HRC, etc. The experimentalresults show that under these conditions, the average surface roughness of specimens is differenced from an original value of Ra 0.551 to 0.356 μm. | |||||
| 言語 | en | |||||
| 書誌情報 |
en : 7th International Conference on INTERNATIONAL CONFERENCE ON SCIENCE, TECHNOLOGY AND EDUCATION ICSTE 2022 p. 6-9, 発行日 2022-09 |
|||||
| 出版者 | ||||||
| 出版者 | International Conference on Science, Technology and Education | |||||
| 言語 | en | |||||
| 著者版フラグ | ||||||
| 出版タイプ | VoR | |||||
| 出版タイプResource | http://purl.org/coar/version/c_970fb48d4fbd8a85 | |||||
